Noyafa NF-268 Manuel d'utilisateur télécharger pdf (Page 7)

Your excellent helper in cable test!

Connect the telephone cable to be tested to RJ11port. Then hold the

receiver to locate the targeted cable as what 3.1 said.

Note: in this case, users should alter the volume to degree 1-3 in order

to find out targeted cable precisely.

3.3 trace monitoring cable (connected to monitor as below)

Connect the telephone cable to be tested to RJ11port. Then hold the

receiver to locate the targeted cable as what 3.1 said.

Note: in this case, users should alter the volume to degree 1-3 in order

to find out targeted cable precisely.

3.4 check short location of non-energized wires (as below)

Connect the bared wires with the two clips, push the key to “scan”,

Keep the probe close to wire, it means normal if “beep” emits. Then

mov e th e p robe al ong t he w ire , the p oin t is s hor t cir cu it wh en no

“beep” comes out.

Note:

1) th e t est ed wi r e mus t b e

non-energized.

2)turn the volume to degree

6-8 when tracing cable.

3)Clip 2 cores to tested

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Noyafa NF-268 Manuel d'utilisateur Page 7